1. Pay attention to the influence of weather conditions on the production of cable heads.
The weather conditions have a relatively large impact on the cold-shrink cable head. The first thing to do is to make it in a sunny weather where the humidity is not very high. If it is made in a relatively humid air condition, the insulation performance of the cable will be greatly reduced, and partial discharge may occur due to moisture. In the construction site, the site is kept clean and clean to the maximum extent, preventing dust from entering the cable during the production process, causing air gaps in the cable and causing breakdown accidents.
2. Take relevant measures to solve the problem of concentrated electric field at the shield end
At the terminal shield of the cable, the electric field is very concentrated. This situation needs to be improved. The current choice is to take measures around the semiconductor to improve this weaker place. If you do not pay attention to this improvement, it is easy to cause cable insulation breakdown.
3. Storage measures after production is completed
After the cable is finished, it needs to be stored well. However, there are also requirements for storage conditions. It is necessary to choose a dry place and seal the storage. The semiconductor tape is wound around the ports of the cold shrink tube and the cold shrink sleeve, which can be waterproof and moisture proof. The winding method is semi-overlapping, starting from the end of the joint, and then performing the reverse winding until the starting position. In the process of winding, it is necessary to control the strength and stretch properly, leaving no gaps.
Ethernet Slip Ring is a device that allows Ethernet signals to be transmitted through a rotating assembly. This device is typically used in applications where it is not possible or practical to run Ethernet cables, such as in an application where the cables would have to travel through a hazardous area. It converts the regular Ethernet signals into rotary signals, which are then transmitted through the rotating assembly.
There is a growing trend in the industry for Ethernet slip rings. Ethernet slip rings are currently being used to interconnect computer networks. A slip ring is a transmission device that uses a counter-rotating encircling belt to transfer power and data between two or more devices.
Senripgrid Conductive Slip Ring has the following characteristics Direct unplugging of the RJ45 connector Upon reaching eight simultaneous ports, follow the standard cable connection method Work with either copper or gas-liquor joints Transmission to the external network (10M, 100M, 1Km Base T).
Ethernet Slip Ring,Generator Collector Rings,Through Bore Rotary Union,Rotary Pressure Joint
Dongguan Oubaibo Technology Co., Ltd. , https://www.sliprobs.com